This image was saved from this machine with hard drive S.M.A.R.T. info at 2025-0604-1739: *****************************************************. For the drive: /dev/sda smartctl 7.4 2023-08-01 r5530 [x86_64-linux-6.7.9-amd64] (local build) Copyright (C) 2002-23, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Device Model: mSATA 3TE7 Serial Number: B0012303240030006 LU WWN Device Id: 5 24693e 001207646 Firmware Version: S22831 User Capacity: 120,034,123,776 bytes [120 GB] Sector Size: 512 bytes logical/physical Rotation Rate: Solid State Device Form Factor: 2.5 inches TRIM Command: Available, deterministic, zeroed Device is: Not in smartctl database 7.3/5528 ATA Version is: ACS-2 (minor revision not indicated) SATA Version is: SATA 3.2, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Wed Jun 4 17:39:47 2025 UTC SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x02) Offline data collection activity was completed without error. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 33) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 2) minutes. Conveyance self-test routine recommended polling time: ( 2) minutes. SCT capabilities: (0x0039) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 5 Reallocated_Sector_Ct 0x0012 100 100 000 Old_age Always - 8 9 Power_On_Hours 0x0012 234 100 000 Old_age Always - 3818 12 Power_Cycle_Count 0x0012 037 000 000 Old_age Always - 549 163 Unknown_Attribute 0x0012 019 000 000 Old_age Always - 19 165 Unknown_Attribute 0x0012 132 000 000 Old_age Always - 132 167 Unknown_Attribute 0x0012 049 000 000 Old_age Always - 49 169 Unknown_Attribute 0x0000 100 000 000 Old_age Offline - 99 170 Unknown_Attribute 0x0013 100 100 001 Pre-fail Always - 255 171 Unknown_Attribute 0x0012 000 100 000 Old_age Always - 0 172 Unknown_Attribute 0x0012 000 100 000 Old_age Always - 0 192 Power-Off_Retract_Count 0x0012 188 000 000 Old_age Always - 444 194 Temperature_Celsius 0x0002 051 100 000 Old_age Always - 51 (3 63 0 21 0) 229 Unknown_Attribute 0x0000 100 100 000 Old_age Offline - 251195517583000 235 Unknown_Attribute 0x0002 000 000 000 Old_age Always - 524288 241 Total_LBAs_Written 0x0012 100 100 000 Old_age Always - 75830 242 Total_LBAs_Read 0x0012 100 100 000 Old_age Always - 46207 SMART Error Log Version: 1 No Errors Logged SMART Self-test log structure revision number 1 No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. The above only provides legacy SMART information - try 'smartctl -x' for more